国产午夜精品理论片,午夜精品久久久久久久久久久久 ,狠狠色综合网久久久久久,亚洲国产av高清无码



Common problems of drying and curing in coating production line
Time:2012-10-22 11:52:48

       Drying and curing equipment is mainly composed of drying chamber, heating system and temperature control. The drying chamber body has through type, through type; Heating system heating mode is fuel (heavy oil, light oil), gas (natural gas, liquefied gas), electric heating (far infrared, electric heating), steam, and so on.


       Drying and curing equipment relatively few problems, but in the heat preservation and energy saving and safety aspects should still cause attention.


       The external surface temperature of drying chamber is too high

       Improper selection of thermal insulation materials is the main reason for poor thermal insulation effect, excessive surface temperature and unsatisfactory thermal insulation performance. This not only increases energy consumption, but also fails to meet the requirements of Article 5.9.2 in the National standard GB1444321993 "Safety Regulations for Coating Operation" : the drying room should have good insulation, and the surface temperature of the outer wall should not be higher than room temperature 15℃.


2. The exhaust pipe is improperly set or not set

       The exhaust pipe of the drying and curing room of some coating lines is not connected to the outside, but in the workshop, the waste gas is directly discharged into the workshop, causing air pollution in the workshop; The exhaust outlet of the drying and curing chamber of some coating lines is not set in the position with the highest concentration of exhaust gas, which is not conducive to the rapid discharge of exhaust gas and the prevention of accumulation. It also does not meet the requirements of national standard GB1444321993 article 5.1.6: The exhaust outlet of the drying room should be set in the area with the highest concentration of combustible gas. After spraying the workpiece into the drying and curing room, because the paint contains organic solvents to varying degrees, the drying and curing process will produce organic solvent waste gas, organic solvent waste gas has flammability, if the waste gas is not discharged from the drying room in time and accumulated in the drying room, once the concentration is too high will cause safety hazards.

Service hotline

020-36860788

WeChat

Feedback

Feedback

尤物蜜芽国产成人精品区| 亚洲日韩欧洲乱码av夜夜摸| 国产v亚洲v天堂a无码99| 国产男女无遮挡猛进猛出| 四虎影视久久久免费观看| 美女网站免费福利视频| 国自产拍偷拍精品啪啪一区二区 | 亚洲成a人片在线观看无码| 国产精品无套内射迪丽热巴| 国产中文成人精品久久久| 欧美激情内射喷水高潮| 亚洲第一福利网站在线观看| 狠狠色噜噜狠狠狠7777奇米| 亚洲精品成人久久电影网| 欧美牲交视频免费观看| 天天做天天爱天天爽天天综合| 人妻 日韩 欧美 综合 制服| 99热这里只有精品国产免费免费| 欧美精品免费观看二区| 夜色阁亚洲一区二区三区| 亚洲ⅴ国产v天堂a无码二区 | 99精品偷自拍| 日本视频高清一道一区| 精品99日产一卡2卡三卡4| 欧美人妻体内射射| 亚洲av日韩av男人的天堂在线 | 亚洲av永久天堂在线观看| 精品亚洲国产成人av在线时间短的| 国产精品视频一区国模私拍| 国产公妇仑乱在线观看| 国产精品美女久久久久av福利| 亚洲国产av一区二区三区丶| 女人爽到高潮免费视频大全| 国产成人午夜福利在线视频| 亚洲av日韩av无码| 99精品无人区乱码1区2区3区| 女人被男人躁得好爽免费视频| 亚洲腹肌男啪啪网站男同| 99久久久无码国产精品性| 超碰成人人人做人人爽| 天躁夜夜躁狼狠躁|